Honda INTERCEPTOR 2002 Service Manual page 219

FUEL SYSTEM (Programmed Fuel Injection)
5-84
Disconnect the ECM 26P (Black) and 26P (Light gray)
connectors.
POWER/ GROUND LINE INSPECTION
Connect the test harness between the main wire
harness and ECM (page 5-9).
TOOL:
ECU test harness 26P
GROUND LINE
070MZ-0010100
(two required)
Check for continuity between the ECM test harness
r
connector 81 terminal and ground, between the 82
terminal and ground, and between the 814 terminal
and ground.
There should be continuity at all times.
If there is no continuity, check for open circuit in
Green/Pink wire and Green wire.
POWER INPUT LINE
Turn the ignition switch ON with the engine stop
switch in RUN position.
Measure the voltage between the ECM test harness
connector 812 terminal (+) and ground.
There should be battery voltage.
If there is no voltage, check fo r an open circuit in the
Black/White wire between the ECM and bank ang le
sensor/relay.
If the wire is OK, check the bank angle sensor/relay
(page 5-82).
ECM