Honda INTERCEPTOR 2002 Service Manual page 167

FUEL SYSTEM (Programmed Fuel Injection)
5-32
Connect the No.4 injector 2P connector.
Turn the ignition switch ON.
Check that the MIL blinks.
Is the MIL blinking?
NO - Loose or poor contact on the No.4 injec-
tor connector.
YES - GO TO STEP 2.
2. No.4 Injector Resistance Inspection
Turn the ignition switch OFF.
Disconnect the No.4 injector 2P connector and
measure the resistance of the No.4 injector 2P
connector terminals.
Connection: Black/white(+) - Pink/black (-)
Standard: 10.5- 14.5
n
(20 °C/68 °F)
Is the resistance within 10.5- 14.5
n
(20 ° C/68
O F)?
NO - Faulty No.4 injector.
YES -GO TO STEP 3.
3. No.4 Injector Short Circuit Inspection
Check for continuity between the No.4 injector
and ground.
Connection: Black/white (+)- Ground(-)
Is there continuity?
YES - Faulty No.4 injector.
NO -GO TO STEP 4.
4. No.4 Injector Power Input Line Inspection
Turn the ignition switch ON.
Measure the voltage between the No. 4 injector
connector of the wire harness side and ground.
Connection: Black/white (+)-Grou nd (-)
Standard: Battery voltage
Does battery voltage exist?
No - Open or short circuit in Black/white
wire.
YES - GO TO STEP 5.
No.4 INJECTOR 2P CONNECTOR
No.4 INJECTOR 2P CONNECTOR
No.4 INJECTOR 2P CONNECTOR
No.4 INJECTOR 2P CONNECTOR
\