Injector - Honda INTERCEPTOR 2002 Service Manual

FUEL SYSTEM {Programmed Fuel Injection)
Install the throttle body into the insulators, tighten
the throttle body side insulator band so that the
insulator band distance is 7
±
1 mm (0.3
±
0.04 in).
Route the throttle stop control cable properly, install
the control knob to the clamp on t he cable stay.
INJECTOR
5-68
INSPECTION
Start the engine and let it idle.
Confirm the injector operating sounds with a sound·
ing rod or stethoscope.
If the injector does not operate, replace the injector.
REMOVAL
Remove the throttle body (page 5-63).
Disconnect the vacuum hose from the pressure reg-
ulator.
Disconnect the TP sensor connector.
Disconnect the injector connectors from each injec-
tor.
Remove the throttle body sub-harness fro m the
throttle body.
1
7 ± 1
mm
(0.3 ±
0.04 in)
...
SOUNDING ROD
INJECTOR