Honda INTERCEPTOR 2002 Service Manual page 454

Apply grease to the new dust seal lips, install them
into the shock link.
Install the pivot collars.
INSTALLATION
Remove the following:
- Shock arm
- Shock arm bolt/nut (frame side)
- Shock link p lates with their "FR" mark f acing to
the forward
- Shock link plate-to-swingarm bolt/nut
- Shock arm bolt/nut (li nk plate side)
- Shock absorber lower mounting bolt/nut
Tighten the shock link arm (frame side) to the speci-
fied torque.
TORQUE: 42 N·m (4.3 kgf·m, 31 lbf.ft)
Tighten the shock link nut to the specified torque.
TORQUE: 42 N·m (4.3 kgf·m , 31 lbf·ft)
Tighten the shock arm bolt/nut (frame side) to the
specified torque.
TORQUE: 42 N·m (4.3 kgf·m, 31 lbf·ft)
Tighten the shock absorber lower mounting nut to
the specified torque.
TORQUE: 42 N·m (4.3 kgf·m, 31 lbf·ft)
REAR WHEEL/SUSPENSION
- - - DUST SEALS
~-- ~
~ \
7
~\
PIVOT COLLAR '
14-25