Honda INTERCEPTOR 2002 Service Manual page 381

CRANKSHAFT / PISTON/ CYLINDER
Remove the nuts and bearing cap.
Measure the compressed plastigauge at its widest
point on the crankpin to determine the oil clearance.
SERVICE LIMIT: 0.05 mm (0.002 in)
If the oil clearance exceeds the service limit, select
the correct replacement bearings.
BEARING SELECTION
Numbers (1, 2 or 3J
Record t he connecting rod I. D. code number (1, 2 o r
on the connecting
3) or measure the I. D. with the bearing cap installed
rods are the codes
w ithout bearing inserts.
for the connecting
rod/.0.
Letters (A, 8 or CJ
If you are replacing the crankshaft, record the corre-
on the crank weight
spending crankpin O.D. code number
{A,
B or C).
are the codes for
If you are reusing t he crankshaft, measure the
the crankpin
O.O.s crankpin O.D. with the micrometer.
from left to right.
Cross-reference the crankpin and rod codes to
determine the replacement bea ri ng color.
CRANKPIN BEARING SELECTION TABLE:
CONNECTING ROD I.D. CODE
CRANKPIN O.D. CODE
CONNECTING ROD I.D.CODE
1
2
3
39.000-39.006 mm 39.006-
39.012
mm 39.012-39.018 mm
(1.5354- 1.5356 in) (1.5357 - 1.5359 in) (1.5359- 1.5361 in)
CRANK PIN O.D. A
35.994 - 36.000 mm
E D
c
CODE (1.4171
-1.4173 in)
(Yellow) (G reen)
(Brown)
B 35.988 - 35.994 mm
D
c
B
(1.4168 -1.417 1 in) (Green) (Brown) {Black)
c
35.982 - 35.988 mm
c
B
A
(1.4166 -1.4168 in) (Brown) (Black) (Blue)
-
12-10