Honda INTERCEPTOR 2002 Service Manual page 384

PISTON INSPECTION
Temporarily install the piston rings to their proper
position with the mark facing up.
Measure the piston ring-to-ring groove clearance
with the rings pushed into the grooves.
SERVICE LIMITS:
Top: 0.11 mm (0.004 in)
Second: 0.10 mm (0.004 in)
Insert the piston ring squarely into the bottom of the
cylinder and measure the ring end gap.
SERVICE LIMITS:
Top: 0.5 mm (0.02 in)
Second: 0.6 mm (0.02 in)
Oil (side rail): 0.9 mm (0.04 i n)
M easure the diameter of the pist on at 18 mm (0.7 in)
from the bottom and 90 degrees to the piston pin
hole.
SERVICE LIMIT: 71.90 mm (2.831 in)
Measure the piston pin bore.
SERVICE LIMIT: 17.02 mm (0.670 in)
CRANKSHAFT / PISTON/ CYLINDER
12-13