Honda INTERCEPTOR 2002 Service Manual page 422

FRONT WHEEL/ SUSPENSION/ STEERING
Note the mstallation
Install the ball race remover into the head pipe as
direction of the
shown. DRIVER ATIACHMENT
assembly base.
Align bearing remover A with t he groove in the
steering head.
lightly tighten nut B with a wrench.
While holding the driver shaft with a wrench, turn
nut A gradually to remove the upper bearing outer
race.
DRIVER ATIACHMENT
Note the installation
Install the ball race remover into the steeri ng head
direction of the
pipe as shown. DRIVER ATIACHMENT
assembly base
Align bearing remover B with the groove in the
steering head.
lightly tighten nut B.
While holding the driver shaft, tu rn nut A gradually
to remove the lower bearing outer ra ce.
BEARING
REMOVER B
DRIVER ATIACHMENT
NUTB
DRIVER SHAFT
DRIVER SHAFT
13-33