Honda INTERCEPTOR 2002 Service Manual page 310

IF ONLY THE FRONT CYLINDER CAM-
SHAFT WAS REMOVED:
Remove the rear cylinder head cover (page 8-6).
Turn the crankshaft clockwise and align the "3T"
mark on the ignition pulse generator rotor with the
index mark on the right crankcase cover.
Make sure the index lines on the rear cam sprockets
are facing outward.
If they are not, turn the crankshaft clockwise one full
turn (360°) and realign the "3T" mark with the index
mark.
Turn the crankshaft clockwise 1-1/4 turn (450°) and
align the "4T" mark on the ignition pulse generator
rotor with the index mark on the right crankcase
cover.
Install the front cylinder camshafts with the index
lines on the cam sprocket faci ng outward.
Install the camshaft holders following the same pro-
cedure as when both the front and rear camshafts
were removed (page 8-38).
CYLINDER HEAD/ VALVES
8-47