Engine Stop Relay; Ecm (Engine Control Module) - Honda INTERCEPTOR 2002 Service Manual

FUEL SYSTEM (Programmed Fuel Injection)
Ins call the bank
Installation is in the reverse order of removal.
angle sensor with
its "UP" mark fac·
Tighten the mounting screws/nuts securely.
ing up.
ENGINE STOP RELAY
INSPECTION
Remove the upper cowl (page 2-12).
Disconnect the engine stop relay 4P connector,
remove the engine stop relay.
Connect the ohmmeter to t he engine stop relay con-
nector t erminals.
Connection: Black/ pink- Black/white
Connect the 12 V battery to the following engine
stop relay connector terminals.
Connection: Red/orange- Black
There should be continu ity only when the 12 V bat·
tery is connected.
If there is no continuity when t he 12 V battery is
connected, replace t he engine stop relay.
ECM (ENGINE CONTROL MODULE)
REMOVAL/INSTALLATION
Remove the upper cowl (page 2·12).
Remove the bolt and ECM cover.
"U P" MARK
BANK ANGLE SENSOR
5-83