Honda INTERCEPTOR 2002 Service Manual page 216

FUEL SYSTEM {Programmed Fuel Injection)
OUTPUT V OLTA GE INSPECTION WITH THROTILE
FULLY CLOSED
Tu rn the ignit ion switch ON and measure and
record the out put volt age with the throttle fully
closed.
Connection:
A16 (+ )- 816 (-)
MEASURING CONDITION:
At throttle fully close
CALCULATE RESULT COMPARISON
Compare the measurement to the result of the fol -
lowing calculation.
With the throttle fully open:
Measured input voltage X 0.824= Vo
The sensor is normal if t he measurement output
voltage measured i n step 2 is within 10% of Vo.
With the throttle fully closed:
Measured input voltage X 0.1= Vc
The senso r is normal if the throttle closed output
voltage measured i n step 3 is within 10%of Vc.
Using an analog mete r, check t hat t he needle of t he
voltmeter swi ngs slowly when the t hrottle is opened
grad ually.
CONTINUITY INSPECTION
Open and support the fue l tank using the equ ipped
tools (page 3-5).
Disconnect
the ECM 26P (Black) and 26P (Lig ht g ray)
connector and the TP sensor 3P connector.
Check fo r continuity between the ECM and TP sen-
sor.
If t here is no continuity, check the open or short cir-
cuit i n wire harness.
L,___-1
v
1----......J
3P CONN ECTOR
ECM 26P (LIGHT GRAY) CONN ECTOR
5-81