Evap Purge Control Solenoid Valve (California Type Only) - Honda INTERCEPTOR 2002 Service Manual

FUEL SYSTEM (Programmed Fuel Injection)
EVAP PURGE CONTROL SOLENOID
VALVE (CALIFORNIA TYPE ONLY)
REMOVAL
Remove the side cowl (page 2-8).
Disconnect the EVAP purge control solenoid valve
2P connector.
Disconnect the air hoses from the EVAP purge con-
trol valve.
Remove the bolt and EVAP purge control valve
bracket assembly.
Installation is in the reverse order of removal.
INSPECTION
Remove the EVAP purge control valve.
Check t hat the air should not flow (A) to (B), only
when the 12 V battery is connected to the EVAP
purge control valve terminals.
2P CONNECTOR
BOLT
EVAP PURGE CONTROL VALVE
(B)
{A)
Check the resistance between the te rminals of the
r--- - - - - - - - - - - -------,
5-88
EVAP purge control valve connector.
STANDARD: 30- 34
Q
(20°C/68°F)
If the resistance is out of specification, replace the
EVAP purge control va lve.
EVAP PURGE CONTROL VALVE