Honda INTERCEPTOR 2002 Service Manual page 398

FRONT WHEEL/SUSPENSION/ STEERING
Install the left handlebar weight and tighten the new
screw to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Install the left handlebar switch housing aligning its
locating pin with the hole in the handlebar.
Tighten the forward screw first, then the rear screw.
Install the clutch lever bracket assembly by aligning
the end of the clutch master cylinder with the punch
mark on the handlebar.
Install the clutch master cylinder holder with the
"UP" mark facing up.
Tighten the upper bolt first, then the lower bolt.
Connect the clutch switch wire connectors.
RIGHT HANDLEBAR INSTALLATION
SWITCH
HOUS~
...
HOLDER MASTER CYLINDER
BOLTS
..,;.
"UP"
MAR~
Apply grease to the throttle cable sliding surface of .------ - -~ -- - - - . T-H_R_O_TT_L_E_C_A_B_L_E_E_N_D_S---,
the throttle pipe.
~
Connect the throttle cables to the throttle pipe.
THROTTLE GRIP
13-9