Honda INTERCEPTOR 2002 Service Manual page 520

ANTI-LOCK BRAKE SYSTEM (ABS)
RETRIEVAL/ERASURE OF PROBLEM CODE
• After retrieval, the ABS indicator indicates the problem code by
blinking a specified number of t imes.
• The problem code is not erased by turning the ignition switch to
"OFF" w hile the problem code is being output. Note that turning the
ignition switch to "ON" again does not indicate t he problem code.
To show the problem code again, repeat the problem code retrieval
procedures from the beginning.
• The ABS control un it stores up to two problem codes and indicates
the latest problem code first, and then the earlier code alternately.
When the two problem codes are indicated, begin diagnostic trou-
bleshooting, beginning with the code that was indicated f irst.
• Be sure to make a note of the re trieval problem code(s).
• After diagnostic troubleshooting, erase the problem code(s) and
perform the pre-start self-diagnosis to be sure that there is no prob-
lem i n the ABS indicator (indicator is operating normally).
RETRIEVAL:
1. Remove the No.1 and 3 control motor fuses with the ignition switch /
turned to "OFF" to be sure that each fuse is not burned out. ;
1
If either f use is burned out, perform the troubleshooting of problem
code "4" (No. 1 fuse) or "5" (No.3 fuse) without installing the fuse.
2. Turn the ignition switch to "ON". The ABS indicator should come
on.
3. Wait fo r 5 seconds and the ABS indicator goes off.
4. Insta ll either the No.1 or the No.3 fuse immed iately after the ABS
indicator is off (wit hin 3 seconds).
5. The problem code is indicated by the number of times the ABS indi-
cator bli nks.
TO ERASE THE PROBLEM CODE:
(
1. Install the remaining fuse (No. 1 or No.3) while the problem code is being indicated (i.e., the ABS indicator is blinking).
2. When code erasure is complete, the ABS indicator stays on.
IGN ITION
SWITCH
ABS
INDICATOR
Remove fuses with ignition
switch turned to "OFF"
ON
~
OFF
5 seconds
ON
:•
OFF
Install either fuse
Install remaining fuse
Problem code (s)
16-5