Honda INTERCEPTOR 2002 Service Manual page 170

FUEL SYSTEM (Programm ed Fuel Injection)
4. Cam Pulse Generator Peak Voltage Inspection at
ECM
Turn the ignition switch OFF.
Connect the cam pulse generator 2P connector.
Disconnect the ECM connectors.
Connect the test harness to the wire harness
connectors.
Crank the engine with the starter motor, and
measure the cam pulse generator peak voltage
at the test harness terminals.
Connection: A14 (+}-ground(-}
Standard: 0.7
v
minimum (20 °C/ 68 °F}
Is the voltage standard value?
NO - Open or short circuit in White/yellow
and/ or Gray wire.
YES - Replace the ECM with a new one, and
inspect it again.
PGM-FI MIL 19 BLINKS (IGNITION PULSE GENERA-
TOR}
1. Ignition Pulse Generator Connection Inspection
Turn the ignition switch OFF.
Disconnect the ignition pulse generator 2P con-
nector.
Check for loose or poor contact on the cam pulse
generator 2P connector.
Place the motorcycle on its side stand.
Connect the cam pulse generat or 2P connector.
Turn the ig nition switch ON.
Turn the starter motor more than 10 seconds
and then check that the MIL blinks.
Check that the MIL blinks.
Is the MIL blinking?
NO - Loose or poor contact on the cam pulse
generator 2P connector.
YES - GO TO STEP 2.
ECM
PEAK VOLTAG E ADAPTOR
IGNITION PULSE GENERATOR
2P CONNECTORS
~-~
5-35