Toyota Celica 1993 AT200 series Repair Manual page 552

BRAKE SYSTEM _ FRONT BRAK
3 S - G E w / o S u
INSTALL PAD SUPPORT PLATES
Install tho 4 pad support Platss.
7.
|I{STALL NEW PADS
(a) Install a pad wear indicator plate on the inside pad.
(b) Apply disc brake greass to both sides of the inner anti
- s q u e a l s h i m .
( c ) I n s t a l l t h e a n t i - s q u e a l s h i m s o n e a c h p a d .
Install inside pad with the pad wear indicator plate
facing upward.
lnstall outsida pad.
N O T I C E : T h e r e s h o u l d b e n o o i l o r g r o a s o s d h e i i n g t o t h e
friction surlaces ot tha pads or the disc.
( f )
I n s t a l l t h e 2 a n t i - s q u s a l s p r i n g s
8 . I N S T A L L C A L I P E R
(a) Draw out a small amount of brake fluid from the
reservolr.
(b) Press in tho piston with watsr pump pliers or similar
i m p l e m e n t .
H I N T : l f t h o p i s t o n i s d i f f i c u l t t o p u s h i n , l o o s e n t h e
b l e e d e r p l u g a n d p u s h i n t h e p i s t o n w h i l e l e t t i n g s o m e
brake fluid esca po.
(c) lnstall the caliper.
( d ) H o l d t h e s l i d i n g p i n a n d t o r q u e t h o i n s t a l l a t i o n b o l t .
Torque: 34 N.m (350 kgf 'cm. 25 ft lbf )
9 .
I N S T A L L F R O N T W H E E L
1 0 . C H E C K T H A T F L U I D L E V E L I S A T M A X L I N E
luh
( d )
(e)