Toyota Celica 1993 AT200 series Repair Manual page 560

B R A K E S Y S T E M - F R O N T B R A K E ( 3 S - G E w / S u
I N S P E C T P A D L I N I N G T H I C K N E S S
C h e c k t h e p a d t h i c k n e s s t h r o u g h t h e c a l i p e r i n s p e c -
tion hole and replace the pads if it is not within the
s o e c i f i c a t i o n .
Minimum thickness:
1 .0 mm (0.039 in.)
3, LIFT UP CALIPER
(a) Hold the sliding pin and loosen the 2 installalion bolts.
(b) Remove the installation bolts.
: B R
(c) Remove the caliper and suspend it securely. Ensure
that hose is not stretcheo.
HINT: Do not disconnoct the flexible hose from the
ca lroe r.
4.
REMOVE FOLLOWING PARTS:
( a ) 2 a n t i - s q u e a l s p r i n g s
(b) 2 brake pads
( c ) 4 a n t i - s q u e a l s h i m s
(d) 4 pad support plates
(e) Pad wear ind icator
5 .
C H E C K D I S C T H I C K N E S S A N D R U N O U T
( S e e p a g e B B - 4 9 )
8.
INSTALL PAD SUPPORT PLATES
Install the 4 pad support plates.
c 6q.**
o