Toyota Celica 1993 AT200 series Repair Manual page 74

MX-33
C52 MANUAL TRANSAXLE _ COMPONENT PARTS RE
27. REMOVE MAGNET FROM TRANSAXLE CASE
C O M P O N E N T P A R T S I N S P E C T I O N
1.
INSPECT sTH GEAR SYNCHRONIZER RING
(a) Check for wear or damag6'
(b) Check the braking effect of the synchronizer ring'
Turn the svnchronizer ring in one direction while push-
ing it to tho gear cone. Check that the ring locks'
lf ths braking effect is insufficient, apply a small
amount of fine lapping compound between the syn-
choronizer ring and gear cone.
Lightly rub the synchronizer ring and gear cons to-
gethsr.
NOTICE: Ensurs ths fins lapping compound is completely
washod otf atter rubbing.
(c) Check again the braking effect of the synchronizer
ring. lf it doos not lock, replace the synchronizer ring'
(dI Using a feeler gauge, measurs the cloarance bstween
t h e s y n c h r o n i z e r r i n g b a c k a n d g e a r s p l i n e e n d '
Minimum clearance:
0.6 mm (0'024 in.)
H I N T :
r
When replacrng sither a synchronizer rlng or
g e a r , a p p l y a s m a l l a m o u n t o f f i n e l a p p i n g c o m -
pound between the synchronizer ring and gear
cong.
Lightly rub the synchronizer ring and gear cone
tog sth e r.
r
When replacing both the synchronizer ring and
gear, lhere is no need to apply any compound or
to rub them together.
NOTICE: Ensurs the tine lapping compound is complstely
washed off after rubbing.