Toyota Celica 1993 AT200 series Repair Manual page 639

sR-20
STEERING - STEERING COLUMN
C o m p r e s s i o n
6ar3.&",-"
\^lat(+@ - -- _
S p r i n g
u p p e r
a i n S h a t t
(d) Remove th6 shaft assembly from the upper tube.
(e) Remove the spring and bearing thrust collar from the
shaft assomblv.
S T E E R I N G C O L U M N I N S P E C T I O N A N D
REPLACEMENT
1 . I N S P E C T K E Y C Y L I N D E R
Check that the stesring lock mechanism operatss pro-
pe rly.
2. IF NECESSARY. REPLACE KEY CYLINDER
(a) Place the ignition key at the ACC position.
(b) Push down th6 stop pin with a thin rod, and pull out
the cylinder.
(c) Install a new cylinder.
HINT: Make sure the ignition key is at the ACC posr-
tio n.
3. IF NECESSARY, REPLACE UNLOCK WARNING
swtTcH
(a) Remove ths 2 scrsws.
(b) Tighten the 2 scrsws.
R09609