Toyota Celica 1993 AT200 series Repair Manual page 410

SUSPENSION
Install the bolt to the bearing bracket.
Torque: 32 N m (330 kgf.cm. 24 ft lbf)
U s i n g p l i e r s , i n s t a l l a n e w s n a p r i n g t o t h a b e a r i n g
brackt.
(a) w/o LSD:
Coat gear oil to the inboard joint and differential
s liding surface.
(b) Install th€ center drive shaft with th€ RH drive shaft
to tho transaxlo through the bearing bracket.
(c) Using pliers, install a n€w snap rang.
(d) Install tho 2 bolts and tighten them.
Torque: 64 N.m (650 kgf cm' 47 ft lbf)
4.
CONNECT DRIVE SHAFT
Install the outboard joint sido of tho drivo shaft to the
axle hub.
NOTICE: Be careful not to damage the inner oil seal'
5.
CONNECT CAMBER CONTROL ARM
(a) Conn€ct the camber control arm to the steering knu-
ckle and tighten th6 nut.
Torque: 172 I{.m (1,750 kgf cm' 127 ft lbf)
(b) Install ths lock cap and a new cottsr pin.
6,
CONNECT LOWER BALL JOINT ATTACHMENT
Connect the lower ball joint attachm€nt to tho stoer-
i n g k n u c k l e a n d t i g h t e n t h e 2 b o l t s a n d n u t .
Torque: 1 08 N.m (1 ,100 kgf 'cm, 80 ft'lbf)
( d )
( € )
t.^,