Toyota Celica 1993 AT200 series Repair Manual page 397

sA-42
S U S P E N S I O N
A N D A X L E _ F R O N T D R I V E S H A F T ( 3 S _ G
F R O N T D R I V E S H A F T R E M O V A L
N O T I C E : T h e h u b b e a r i n g c o u l d b e d a m e g e d i f i t i s s u b -
j e c t e d t o t h e v e h i c l e w s i g h t . s u c h a s w h s n m o v i n g t h e
vehicl6 ryith the drive shsft removod. Therefore, if it rs
a b s o l u t e l y n o c o s s a r y t o p l a c e t h o v o h i c l e r v e i g h t o n i h e
h u b b e a r i n g , f i r s t s u p p o r t i t w i t h S S T .
s s T 0 9 6 0 8 - 1 6 0 4 1 ( 0 9 6 0 8 - 0 2 0 2 0 , 0 9 6 0 8 - 0 2 0 4 0 )
w/ABS:
After disconnecting the drivs shaft from the axle hub,
work carefully so as not to damage the sensor rotor
serrations on the drive shaft.
J A C K U P V E H I C L E A N D R E M O V E F R O N T W H E E L
R E M O V E E N G I N E U N O E R C O V E R S
D R A I N T R A N S A X L E O I L
R E M O V E C O T T E R P I N , L O C K N U T C A P A N D L O C K
N U T
Removs th6 cottor pin and lock nut cap.
L o o s e n t h e b e a r i n g l o c k n u t w h i l a d e p r e s s i n g t h e
brake oedal.
5 . D I S C O N N E C T T I E R O D E N D
(a) Remove th6 cottsr pin and nut from the steering
knuckle.
(b) Using SST, disconnect the tie rod end from th6 ste6r-
i n g k n u c k l e .
s s T 0 9 6 2 8 - 6 2 0 1 1
1 .
2 .
3.
( a )
(b)
4.
6. DISCONNECT STABILIZER BAR LINK
Rsmove th6 nut and disconnect the stabilizer bar link
f rom shock absorber.
H I N T : l f t h e b a l l j o i n t s t u d t u r n s t o g e t h e r w i t h t h s n u t .
use a haxagon wrench to hold the stud.