Toyota Celica 1993 AT200 series Repair Manual page 103

MX-62
C52 MANUAL TRANSAXLE - DIFFERENTIAL CASE
4.
INSTALL RING GEAR ON DIFFERENTIAL CASE
(a) Clean the contact surface of ths difforontial case.
(b) Hoat the ring gear in boiling water.
(c) Carefully rsmove th6 ring gear from the water.
(d) After the moisture on the ring gear has completaly
evaporated, quickly install the ring gear to ths diffsr-
I ntra I caso.
HINT: Align the matchmarks on the differential case
and contact the ring gear.
Temporary install the 4lock plates and 8 bolts.
NOTICE: The ring goar sat bolts should not be tightensd
until tha ring gaar has coolad sufficiantly.
Aft6r th6 ring gaar has cooled sufficiently, torque the
ring gear's sat bolts.
Torque: 97 N.m (985 kgf.cm,71 ft.lbf)
U s i n g a h a m m e r a n d d r i f t p u n c h , s t a k e t h e l o c k i n g
plate.
HINT: Stake one claw flush with the flat surface of the
nut. For the claw contacting the protruding portion of
the nut, stake only th6 half on the tightening side.
5.
INSPECT DIFFERENTIAL SIDE BEARING PRELOAD
(a) Install the differantial case assembly to tho transaxlo
ca se.
(b) lnstall th€ transmission cas€.
(c) Install and torque the bolts.
Torque: 29 N.m (300 kgf.cm,22 ft.lbf)
(e)
(f)
(s)
tr--
\
cM0061