Toyota Celica 1993 AT200 series Repair Manual page 854

B O D Y E L E C T R I C A L S Y S T E M - C R U I S E C O N T R O L S Y S T E M
8 E . 1 2 1
N E U T R A L S T A R T S W I T C H I N S P E C T I O N
INSPECT NEUTRAL START SWITCH
See AX Section
S P E E D S E N S O R I N S P E C T I O N
I N S P E C T S P E E D S E N S O R
See page BE - 65
A C T U A T O R I N S P E C T I O N
1 . I N S P E C T A C T U A T O R M A G N E T I C C L U T C H
(a) Check that the arm can be moved smoothly by hand.
(b) Connect ths positiva (+) lead from the battery to
N 1 1 0 5 6 8 E . 3 7 6
t e r m i n a l 5 a n d t h e n o g a t i v e ( - ) l e a d t o t s r m i n a l O .
f f i
( M a g n e t i c C l u t c h t u r n e d O N )
F
(c) Check that the arm cannot be movod bv hand.
lf operation is not as specified, rsplace the motor.
2 .
I N S P E C T A C T U A T O R M O T O R
(a) With the magnetic clutch ON, connect the positive
(+) lead from tho battery to terminal 6, and tho naga-
tive (-) lead to terminal 7, check that th€ arm movos
t o t h e o p 6 n s i d e .
(b) When the arm reachsd to th6 opon position, check
that the motor operation stops.
(c) With the magnetic clutch ON, connoct the positive
(*) lead from the battery to terminal 7 and the nega-
tive (-) l6ad to terminal 6, check that th€ arm mov€s
to the clos€ sido.
(d) When the arm reaches to the closed position, check
that the motor op€ration stops.
N 1 1 1 7 0 8 4 4 3 7 9