Toyota Celica 1993 AT200 series Repair Manual page 377

sA-22
suattnsroN AND AxLE - FRoNT
S H O C K A B S O R B E R W I T H S T E E R I N G
K N U C K L E A S S E M B L Y
CONNECT SHOCK ABSORBER TO STEERING KNU-
C K L E
(a) Clamp the steering knuckle in a vise.
(b) Install th6 upper ball joint with shock absorber and
tighten the nut.
Torque: 99 N.m (1,010 kgf .cm, 73 ft'lbf)
(c) Install a now cottor pin.
S H O C K A B S O R B E R W I T H S T E E R I N G
K N U C K L E I N S T A L L A T I O N
1. INSTALL SHOCK ABSORBER WITH STEERING
K N U C K L E
Placa the shock absorber and install the 3 nuts.
Torque: 80 N.m (800 kgf .cm, 59 fr'lbf)
2.
CONNECT DRIVE SHAFT
(a) Install th6 drive shaft to the axla hub.
(b) Temporarily install the lock nut.
NOTICE: Be carcful not to d8mag. tho boot. ond Inner oil
real.
3.
CONNECT CAMBER CONTBOL ARM
(a) Connect the camber control arm to tho shock ab-
sorber and tighEn the nut.
Torque: 171 N.m (1,754 kgf.cm, 129 ft.lbf)
(b) Install the lock cap and a now cotter pin.
1.
CONNECT LOWER BALL JOINT ATTACHMENT
Connect the lower ball joint attachm€nt to tho st€er-
ing knuckle and tighten the 2 bolts and nut.
Torque: 108 N.m (1,100 kgf.cm, 80 ft'lbf)
Y'