Toyota Celica 1993 AT200 series Repair Manual page 438

S U S P E N S I O N
A N D A X L E - F R O N T D R I V E S H A F T ( 7 A -
4 .
C O N N E C T D R I V E S H A F T T O A X L E H U B
Install the outboard joint side of the drive shaft to tho
axle hub.
NOTICE: Be careful not to damago the inner oll rcal,
boots and ABS speed 86n8or rotor,
ry
CONNECT LOWER BALL JOINT TO LOWER ARM
Connect the lower ball joint to th6 lower arm and
tighton th6 bolt and 2 nuts.
Torque: 127 N.m (1,300 kgf.cm, 94 ft.lbf)
6.
CONNECT STABILIZER BAR LINK TO LOWER ARM
Torque:44 N.m (450 kgf.cm,33 ft.lbf)
H I N T : l f t h e b a l l j o i n t s t u d t u r n s t o g e t h e r w i t h t h g n u t ,
use a hexagon wrench to hold the slud.
7 ,
C O N N E C T T I E R O D E N D T O S T E E R I N G K N U C K L E
(a) Conn6ct th6 lio rod end to steering knuckle and tight-
6 n t h e n u t .
Torque:49 N.m (500 kgf.cm,36 ft.lbf)
(b) Install a n6w colter pin.
8,
INSTALL DRIVE SHAFT LOCK NUT
(a) Tighten th€ lock nut.
Torque: 216 N m (2,200 kgf.cm, 1 59 ft.lbf)
(b) Install the lock cap and a n6w cotter pin.