Toyota Celica 1993 AT200 series Repair Manual page 663

sR-44
STEERING _ POWER STEERING
(@
L o c k P o s i t i o n
8. CHECK PRESSURE READING WITH STEERING
W H E E L T U R N E D T O F U L L L O C K
Be sure the valv6 of the oil pressure gauge is fully
o p e n e d , a n d t h e e n g i n e i d l i n g .
M l n i m u m p r e s s u r e l 7 A - F E
6 , 8 6 5 k P a ( 7 0 k s l / c m ' , 9 S 6 p s i )
M i n i m u m p r e s s u r e : 3 5 - G E , 3 5 - F E , 5 5 - F E
8,826 kPa (90 kgf,/cm", 1,280 psi)
N O T I C E :
. D o n o t m a i n t a i n l o c k p o s i t i o n f o r m o r e t h a n 1 0
a o c o n d s .
.
D o n o t l e t t h e f l u i d t e m p s r a t u r a b e c o m e t o o h i g h .
l f p r e s s u r e i s l o w , t h e P S g e a r h o u s i n g h a s a n i n t e r n a l
l e a k a n d m u s t b o r e p a i r e d o r r e p l a c e d .
9 . D I S C O N N E C T O I L P R E S S U R E G A U G E
7 A - F E :
(a) Remove the return hose, and drain fluid.
NOTICE: Take cars not to spill fluid on the drive belt.
( b ) D i s c o n n e c t t h e g a u g e .
(c) Connect the pressure feed tubo with the union bolt
with 2 new gaskets.
H I N T : M a k e s u r s t h e s t o p p o r i s t o u c h i n g t h e p u m p
housing, as shown, thon torque the bolt.
Torque: 52 N.m (525 kgf .cm. 38 ft.lbf)
(d) Connect the return hosa.
(e) Bl6ed the power steering system.
( S e e p a g e S R - 4 1 )
3 5 - G E , 3 5 _ F E , 5 5 _ F E :
( a ) I n s t a l l t h e t u b e c l a m p .
1
R e t u r n H o s €
Pressur€
F e e d T u b e
/-{4'
" i*J
lrt-\(
R Q 9 0 2 2
F O 9 6 3 t