Toyota Celica 1993 AT200 series Repair Manual page 363

sA-8
SUSPENSION AND AXLE - WHEEL ALIGNMENT
SA
4 , A D J U S T T O E - I N
(a) Remove tho boot clamps.
(b) Loosen the ti€ rod snd lock nuts.
(c) Turn the left and right tie rod ends an equal amount to
adjust the toe - in.
Toe- in (iotal):
A * B : 0 ' + 6 '
( C - O : 0 t I m m , 0 + 0 . 0 4 i n . )
HINT: Measure that the lengths of the lsft and right tre
rod end length are the same.
Tie rod end length difference:
1,5 mm (0.059 in.) or lerr
(d) Torque the tie rod end lock nuts.
Torque: 56 N.m (570 kgf.cm,42 ft.lbf)
(e) Place the boot on tho soat and install th€ clamp.
HINT: Make sure that the boots are not twisted.
5. INSPECT WHEEL ANGLE
Whoel angle
lnsido whool
Outside wh6ol
(rof6renc6)
36"54' a 2"
30'44'
lf th€ wh6el angles diffar from tho specification, check
the difference of the loft and right tie rod end length.
Tie rod end length difference:
1 . 5 m m ( 0 . 0 5 9 i n . ) o r l e s s
F r o n t
t
A : I n s i d e
B : Outside