Toyota Celica 1993 AT200 series Repair Manual page 800

B E - 6 7
BODY ELECTRICAL SYSTEM - COMBINATION METER
2 .
I N S P E C T F U E L S E N D E R G A U G E R E S I S T A N C E
Measure tho resistance between terminals 2 and 3 f or
each f loat Position.
lf resistance value is not as specified. replace the
s e n d e r g a u g e .
F U E L L E V E L W A R N I N G L I G H T
I N S P E C T I O N
I N S P E C T F U E L L E V E L W A R N I N G L I G H T
( a ) D i s c o n n e c t t h e c o n n e c t o r f r o m t h e s e n d e r g a u g e .
(b) Connect terminals 1 and 3 on the wire harness side
connecror.
( c ) T u r n t h e i g n i t i o n s w i t c h O N , c h e c k t h a t t h e w a r n i n g
l i g h t i i 9 h t s u p .
l f t h e w a r n r n g l i g h t d o e s n o t l i g h t u p . t e s t t h e b u l b o r
inspect wire ha rness.
F U E L L E V E L W A R N I N G S W I T C H
I N S P E C T I O N
INSPECT FUEL LEVEL WARNING SWITCH
(a) Apply battsry voltage between terminals 1 and 3
through a 3.4 W test bulb, chock that the bulb lights
u p .
HINT: lt will take a short timo for the bulb to light up.
(b) Submerge tha switch in fuel, check that ths bulb goes
out.
lf operation is not as specified, replace the sender
g a u g s .
Float position mm (in.)
R e s i s t a n c e ( Q )
F
A p p r o x . 2 7 . 6 { 1 . 0 9 )
A p p r o x . 3 . 0
1 / 2
A p p r o x . 3 3 . 7
( 1 . 3 3 ) A p p r o x . 3 1 . 6
E
Approx. 92.7 {3 65)
A p p r o x . I 1 0 . 0
. " +
l g n l t ! o n
S w i t c h
Battery
T
B E I 2 1 7 l e 5 1 . A
l | 8 1
W a r n i n g