Toyota Celica 1993 AT200 series Repair Manual page 427

sA-72
suspENsroN AND AxLE - FRoNT DRrvE sHAFT(3s-FE, ss-FE)
6, CONNECT STABILIZER BAR LINK TO LOWER ARM
Torque:44 N.m (450 kgf.cm.33 ft.lbf)
HINT: lf the balljoint stud turns togethor with ths nut,
use a hexagon wrench to hold the stud.
7 .
C O N N E C T T I E R O D E N D T O S T E E R I N G K N U C K L E
(a) Connect the tie rod end to the steering knuckle and
torq ue tho nut.
Torque: 49 N.m (500 kgf .cm. 36 fr.lbf )
(b) Install a new cottsr pin.
HINT: lf the cotter pin hole does not line up, correct by
tightening the nut by the smallest amount possible.
8.
INSTALL BEARING LOCK NUT. LOCK NUT CAP
AND NEW COTTER PIN
(a) Install and torque the lock nut.
T o r q u e : 2 1 6 N . m ( 2 , 2 0 0 k g f . c m , 1 5 9 t t . l b f )
( b ) I n s t a l l t h e l o c k n u t c a p a n d s s c u r e i t w i t h a n e w c o t t e r
p t n .
9. FILL TRANSAXLE WITH GEAR OIL (M/T) OR ATF
(A/r)
1 0 . I N S T A L L E N G I N E U N D E R C O V E R S
1 1 . I N S T A L L F R O N T W H E E L A N D L O W E R V E H I C L E
T o r q u e : 1 0 3 N . m ( 1 . 0 5 0 k s f . c m , 7 6 f t . l b f )
I 2 . C H E C K A N D A D J U S T F R O N T W H E E L A L I G N M E N T
(See page SA-7)
13. w/ ABS:
CHECK ABS SPEED SENSOR SIGNAL
(See pase BR - 93)