Toyota Celica 1993 AT200 series Repair Manual page 589

B R - 7 4
B R A K E S Y S T E M - A N T I - L O C K B R A K E S Y S T E M ( A B S )
HINT: The first number of blinks will equal the first
digit of a 2 digit diagnostic rrouble code. After a 1.5
second pause, th6 2nd number of blinks will equal the
2nd number of a 2 digit code. lf there are 2 or more
codes, there will be a 2.5 second oause between each.
Indication will start from the smallest and finish at the
largest numbered code. This sequence will be repeat-
ed after a 4 seconds oause.
lf the syst6m is operating normally (no malfunction),
the warning light will blink once every 0.5 seconds.
Repair tha system.
Aft6r the malfunctioning compon€nts has been repai-
red, clear the diagnostic trouble codes stored in the
E C U .
(See page BR - 76)
HINT: lf you disconnect tho battery cable while repair-
ing. all diagnostic trouble codes in the ECU will erased.
Remove the SST from terminals Tc and E, of tha
check connector.
ssT 09843- r 8020
Install th6 short pin to tho terminals WA and WB.
Turn the ignition switch on, and check that the'ABS'
warning light goes off after the warning light goes on
for 3 seconds.
0 . 2 5
o.25
(e)
(f)
(g)
B R
(h)
(i)
0)