Toyota Celica 1993 AT200 series Repair Manual page 437

sA-82
S U S P E N S I O N
A N D A X L E - F R O N T D R I V E S H A F T ( 7 A - F E )
7, RH ORIVE SHAFT:
ASSEMBLY DAMPER CLAMP
(a) Be sure the damper clamp is on the shaft groove.
(b) Check the distance, as shown.
Distanca:
4 1 8 . 0 m m t 5 . 0 m m ( 1 6 . 4 6 1 + 0 . 1 9 7 i n . )
(c) Using a screwdriver, bend the band and lock it as
shown in the illustratio n.
F R O N T D R I V E S H A F T I N S T A L L A T I O N
1 . I N S T A L L N E W S N A P R I N G
( a ) U s i n g a s n a p r i n g e x p a n d e r , i n s t a l l a n e w s n a p r i n g .
(b) Coat gear oil to the inboard joint tulip and differential
c a s e s l i d i n g s u r f a c e .
2 . I N S T A L L D R I V E S H A F T
L H D R I V E S H A F T :
Using a brass bar and hammer, install the drive shaft
to the tra nsa xls.
N O T I C E : 8 6 c a r e t u l n o t t o d a m a g e t h e b o o t s .
R H D R I V E S H A F T :
U s i n g a s c r e w d r i v s r a n d h a m m e r , i n s t a l l t h e d r i v e
shaft to tha transaxle.
N O T I C E : B e c a r e f u l n o t t o d a m a g o t h a b o o t s .
3 . C H E C K I N S T A L L A T I O N O F F R O N T D R I V E S H A F T
( a ) C h e c k t h a t t h o r e i s 2 - 3 m m ( 0 . 0 8 - 0 . 1 2 i n . ) o f p l a y r n
a x i a l d i r e c t i o n .
( b ) C h e c k t h a t t h e d r i v e s h a f t w i l l n o t c o m e o u t b y t r y i n g
t o p u l l i t c o m p l e t e l y o u t b y h a n d .