Toyota Celica 1993 AT200 series Repair Manual page 609

BR-94
BRAKE SYSTEM _ ANTI_LOCK ERAKE SYSTEM (ABS)
:tr-,:u:t:.111.r.-
f"':3R
(c) Check that th6re is no continuity botwoen each termt-
nal and sensor body.
lf there is continuity, replace the sensor.
(d) Connect tho sp€gd sonsor conn6ctor.
2,
INSPECT SENSOR INSTALLATION
Check that the s6nsor installation bolt is tight6ned
properly. lf not, tighten ths bolt.
Torque: 8.0 N.m (82 kgf.cm,71 in..lbf)
3.
VISUALLY INSPECT SENSOR ROTOR SERRATIONS
(a) Remove the drive shaft
( S e e p a g e S A - 4 1 , 6 0 , 7 5 )
(b) Inspect the ssnsor rotor serrations for scratches,
cracks, warping or missing t€eth.
(c) Install the drive shaft.
( S e e p a g e S A - 4 1 , 6 0 , 7 5 )
4. PERFORM SPEED SENSOR SIGNAL CHECK
(See page BR - 82)
FRONT SPEED SENSOR REMOVAL
HINT: When replacing th6 sensor or sensor harngss,
replace the sensor and sensor harnsss together as a
s6t.
1 .
D I S C O N N E C T S P E E D S E N S O R C O N N E C T O R
(a) Remove the fsnder shiald,
(b) Disconnect the speod sensor connector.
2, REMOVE SPEED SENSOR
w/o Supar Strut Typo Suspension:
(a) Remove tho 3 clamp bolts holding tho sensor harness
from tha bodv and shock absorber.