Toyota Celica 1993 AT200 series Repair Manual page 932

BO-51
B O D Y _ S L I D I N G R O O F
S. ,.-ButYl
ra1e
s-
S L I D I N G R O O F A S S E M B L Y
ASSEMBLE SLIDING BOOF PARTS BY FOLLOWING DIS-
ASSEMBLY SEOUENCE IN BEVERSE
H I N T : W h e n i n s t a l l i n g t h o c a b l e g u i d e c a s i n g , u s e
butyl tape to cover the cut position of the woatherst-
rip at the connaction betwsen tha guide casing and
g u i d e r a i l .
S L I D I N G R O O F I N S T A L L A T I O N
I N S T A L L S L I O I N G R O O F P A R T S B Y F O L L O W I I { G R E .
M O V A L S E O U E N C E I N R E V E R S E
1 , A D J U S T D R I V E R A I L
(a) Operate the drive rail to a closed and tilted down
posr on.
(b) Using a screwdriver, slide the link forward or rearw"rd ffi
to align the marks as shown.
2.
INSTALL ORIVE GEAR
(a) Remove the screw and cam plate cover.
(b) R€movo tho large screw, washers and shims.
(c) Turn the drive shaft by screwdriver to align the hous-
ing and gear point mark as shown.
(d) Install the cam plat6 cover with th6 scr€w.
Point L/arks