Toyota Celica 1993 AT200 series Repair Manual page 532

B R . 1 7
B R A K E S Y S T E M - M A S T E R C Y L I N D E R
M A S T E R C Y L I N D E R C O M P O N E N T S
I N S P E C T I O N
HINT: Clean the disassomblod parts with compressed
a ir.
1 .
I N S P E C T C Y L I N D E R B O R E F O R R U S T O R S C O R I N G
2.
INSPECT CYLINDER FOR WEAR OR DAMAGE
lf necessarv, clean or replace the cylinder'
M A S T E R C Y L I N D E R A S S E M B L Y
1. APPLY LITHIUM SOAP BASE GLYCOL GREASE TO
RUBBER PARTS INDICATED BY ARROWS
2.
INSTALL PISTONS
NOTICE: Ba careful not to damage tho fubbei lips on tho
pirtons.
(a) Insert the 2 pistons straight in, not at an angl6.
NOTICE: It insorted 8t 8n angle, there is a possibility that
tho cylinder boro could be damaged.
(b) Push in the piston with a screwdriver and install the
snap ring with snap ring Pliers.
HINT: Tape tho screwdrivsr tip before use.
3,
INSTALL PISTON STOPPER BOLT
Using a screwdriver, push the piston in all the way and
install th€ pislon stopper bolt ovar a new gasket.
Torque tho bolt.
Torque: 10 N.m (1 00 kgf .cm, 7 ft'lbf)
4 .
I N S T A L L 2 G R O M M E T S
t
+€)
*
I
.>9
* k
@@tr'r'
w / o A B S
\
+€)
*
\
+€)
*
*
*
*
w i A B S