Toyota Celica 1993 AT200 series Repair Manual page 988

AC-33
AIR CONDITIONING SYSTEM - COOLING UNIT
H e x a g o n w r e n c h
C O O L I N G U N I T A S S E M B L Y
INSTALL COMPONENTS ON EVAPORATOR
(a) Using a hexagon wrench, install the €xpansion valve
to the evaporator. Torque the 2 bolts.
Torque: 5.4 N.m (55 kgf cm,48 in"lbf)
HINT: Be suro that tha O - rings are positionod on tho
tub€ fitting.
(b) Install th6 lower unit case to the 6vaporator.
(c) lnstall the thormistor to the evaporator.
(d) Install the upper unit case.
(e) Install tho 4 screws.
(f)
Install the 4 cliPs.
(g) Connect the connectors.
C O O L I N G U N I T I N S T A L L A T I O N
1 . I N S T A L L C O O L I N G U N I T
Install the cooling unit with 3 nuts and 4 screws.
2.
CONNECT CONNECTORS
**l*#
3.
INSTALL INSTRUMENT PANEL AND REINFORCE.
""Eq
M E N T
(See page BO - 52)
4,
INSTALL DRAIN PIPE GROMMET
5.
INSTALL GROMMETS ON INLET AND OUTLET FIT.
T I N G
6 . C O N N E C T L I O U I D T U B E T O C O O L I N G U N I T I N L E T
FITTING
T o r q u e : 1 0 N . m ( 1 0 0 k g f ' c m , 7 f t ' l b t )
7,
CONNECT SUCTION TUEE TO COOLING UNIT
OUTLET FITTING
T o r q u e : 1 0 N . m ( 1 0 0 k g f ' c m . 7 f t l b f )
8. IF EVAPORATOR
WAS REPLACED, ADD COMPRES.
SOR OIL TO COMPRESSOR
A d d 4 0 c c ( 1 . 4 t l . o z . )
C o m p r o S s o ? o i l :
N D O I L 8 o r o q u i v a l e n t
9.
CONNECT NEGATIVE (-) TERMINAL CABLE TO
BATTERY
10. EVACUATE AIR IN REFRIGERANT SYSTEM AND
CHARGE WITH REFRIGERANT
Specified amount:
650 + 50 g (22'92 + 1.76 oz.)
1 1 . T N S P E C T A , / C O P E R A T I O N