Toyota Celica 1993 AT200 series Repair Manual page 563

8R.48
B R A K E S Y S T E M - F R O N T B R A K E ( 3 S - c E w / S u o e r S t r u t T
3.
REMOVE PISTON SEALS
Using a screwdriver, remove the piston seals from the
cvlin d e r.
4 . R E M O V E S L I D I N G P I N S A N D D U S T B O O T S
(a) Remove th6 2 sliding pins from the torque plato.
(b) Using a screwdriver and hammer, tap out the 2 dust
boots.
F R O N T B R A K E C O M P O N E N T S
I N S P E C T I O N A N D R E P A I R
1 . M E A S U R E P A D L I N I N G T H I C K N E S S
U s i n g a r u l e r , m s a s u r e t h e p a d l i n i n g t h i c k n e s s .
S t a n d s r d t h i c k n g s s :
1 2 . 0 m m ( 0 . 4 7 2 i n . l
M i n i m u m t h i c k n e s s :
1 . 0 m m ( 0 . 0 3 9 i n . )
Replace th6 pads as a set if the pad's thickness is at
the minimum thickness or less, or if the oad has
severe unov6n woar.