Toyota Celica 1993 AT200 series Repair Manual page 661

sR-42
STEERING - POWER STEERING
B
,s\
&)
2, START ENGINE AND TURN STEERING WHEEL
FROM LOCK TO LOCK 3 OR 4 TIMES
With the engine speed below 1,000 rpm, turn the
steering whsel to right or left full lock and keep it
thsrs for 2 - 3 seconds, thsn turn the wheal to the
opposite full lock and keeo it there for 2 - 3 seconds.
3. CHECK THAT FLUID IN OIL RESERVOIR IS NOT
FOAMY OR CLOUDY AND DOES NOT RISE OVER
M A X I M U M W H E N E N G I N E I S S T O P P E D
Measure the fluid level with the ongine running. Stop
t h s e n g i n e a n d m e a s u r e t h e f l u i d l s v s l .
Maximum rise:
5 mm (0.20 in.)
lf a problem is found, repeat 'POWER STEERING
F L U I D R E P L A C E M E N T " o n p a g € s S R - 4 0 a n d 4 1 .
Repair the PS if the problem persists.
O I L P R E S S U R E
C H E C K
1 . C O N N E C T O I L P R E S S U R E
G A U G E
7A - FE:
(a) Disconnect ths return hose from the oil reservoir, and
d r a i n f l u i d .
NOTICE: Taks care not to spill fluid on the drive bett.
(b) Remove the union bolt, gasket and disconnect the
pressu re feed tube.
(c) Connect th6 gaugs over a new gasket, as shown in the
illustration.
(d) Connect the return hose.
(o) Bleed th6 powor steering syst6m.
( S e e p a g e S R - 4 1 )
3 5 - G E , 3 5 - F E , 5 5 _ F E :
(a) Using SST, disconnect the pressure feed tube.
ssT 09631 -22020
Oil Pressure
P r s s g u r e T u b e
G a u g e
l n
a n e P u m p
O u t
cos3
Pressu re Feed
T u b e