NEC Univerge SV8100 Features And Specifications Manual page 255

UNIVERGE SV8100
Programmable Function Keys
Trunk Group Routing
Trunk Groups
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
10-03-XX ETU Setup
11-01-01 System Numbering
11-09-01 Trunk Access Code
11-09-02 Trunk Access Code – 2nd Trunk
Route Access Code
11-10-27 Service Code Setup (for System
Administrator) – Trunk Port
Disable for Outgoing Calls
11-11-13 Service Code Setup (for Setup/
Entry Operation) – Display
Language Selection for Multiline
Terminal
11-12-01 Service Code Setup (for Service
Access) – Bypass Call
SV8100 Features and Specifications Manual
Description/Comments
Use program 10-03-XX to setup
and confirm the basic configuration
data for each blade. This program
represents different data depending
on the blade installed in the slot.
Please refer the SV8100
Programming Manual for a more
detailed description of this program.
Use to set system numbering plan.
If required, change the single-digit
Trunk Access Code (normally 0). If
you change this code, you must
also review the settings in Program
11-01-01 for the new code selected.
Assign the Service Code set up in
Program 11-01-01 for Alternate
Trunk Route Access.
Define the service code which
should be used by an extension
user to block a trunk from being
used for outgoing calls.
Select the service code which can
be used at an extension to change
the displayed language on a
multiline terminal display
Define the service code for
Activating Call Forwarding/Do Not
Disturb Override. This code is
available only if you disable the
voice mail Single Digit dialing code
in Program 11-16-09.
Assigned Data
1
The assigned data
varies depending on
the blade installed in
the slot. Please refer
to the SV8100
Programming Manual
for a more detailed
description of the
10-03-XX programs.
Refer to UNIVERGE
SV8100 Programming
Manual
Dial (up to four digits)
(default = 0)
Dial (up to four digits)
(default not assigned)
MLT, SLT
(default = 645)
MLT
(default = 678)
MLT, SLT
(default = 707)
Issue 1.0
Level
2 3
2 - 231