Toyota T100 1996 Service Manual page 639

4 Check center airbag sensor assembly.
Center Airbag
Sensor Assembly
ACC ON
or
DLC1
E1
Tc
W05582
AB0118 AB0119 AB0069
S08098 W02042
OK
1996 TOYOTA T100 (RM449U)
DIAGNOSTICS
D Squib
Spiral
Cable
D− D+
Code 11
H00324
− SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Connect connector to center airbag sensor assembly.
(b) Using a service wire, connect D+ and D− on spiral cable
side of connector between spiral cable and steering
wheel pad.
(c) Connect negative (−) terminal cable to battery, and wait
at least 2 seconds.
CHECK:
(a) Turn ignition switch to ACC or ON, and wait at least 20 se-
conds.
(b) Clear malfunction code stored in memory.
(See page DI−365)
(c) Turn ignition switch to LOCK, and wait at least 20 se-
conds.
(d) Turn ignition switch to ACC or ON, and wait at least 20 se-
conds.
(e) Using SST, connect terminals Tc and E1 of DLC1.
SST 09843−18020
(f) Check DTC.
OK:
DTC 11 is not output.
HINT:
Codes other than code 11 may be output at this time, but they
are not relevant to this check.
NG Replace center airbag sensor assembly.
DI−375