Atm Class-Vc - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

atm class-vc

atm class-vc vcClassName
Syntax
no atm class-vc [ vcClassName ]
Command introduced in JUNOSe Release 7.3.0.
Release Information
Assigns a previously configured VC class to a base profile for a dynamic ATM 1483
Description
subinterface. Issuing this command applies the set of attributes in the specified VC
class to all bulk-configured VC ranges that are dynamically created from this profile.
The no version removes the VC class association with the base profile.
Options
Profile Configuration
Mode
168
atm class-vc
vcClassName Name of the VC class configured with the vc-class atm command