Atm Vc Class Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

ATM VC Class Configuration Mode

Copyright © 2010, Juniper Networks, Inc.
From Global Configuration mode, type the interface command and specify the ATM
subinterface identifier to enter Subinterface Configuration mode. From Subinterface
Configuration mode, type the pvc command and specify the virtual circuit descriptor
(VCD), virtual path identifier (VPI) and virtual circuit identifier (VCI) values (in the format
vpi/vci), and then press Enter.
host1(config)#interface atm 3/2.1
host1(config-subif)#pvc 100 0/100
host1(config-subif-atm-vc)#?
cbr Configure the Constant Bit Rate (CBR) service class
class-vc Assign a Virtual Circuit class to the Permanent Virtual
Circuit
default Set a command to its default(s)
do Run an exec mode command (alias command run)
encapsulation Configure the ATM encapsulation
exit Exit from the current command mode
help Describe the interactive help system
inarp Configure the Inverse Address Resolution Protocol (InARP)
protocol
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
oam Configure Operations, Administration, and Management (OAM)
oam-pvc Configure Operations, Administration, and Management (OAM) for
Permanent Virtual Circuit (PVC)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
ubr Configure the Unspecified Bit Rate (UBR) service class
vbr-nrt Configure the Variable Bit Rate Non-Real Time (VBR-nrt)
service class
vbr-rt Configure the Variable Bit Rate Real Time (VBR-rt) service
class
In this mode, you can configure a class of attributes for an ATM data PVC. The VC class
can include attributes for the service category, encapsulation method, F5 OAM options,
and Inverse ARP. You then apply the set of attributes as a group by assigning the VC class
to an individual PVC, to all PVCs created on a specified ATM major interface, to all PVCs
created on a specified ATM 1483 subinterface, or to a base profile from which
bulk-configured VC ranges are dynamically created.
From Global Configuration mode, type the vc-class atm command followed by an
alphanumeric VC class name of up to 32 characters, and press Enter.
host1(config)#vc-class atm premium-subscriber-class
host1(config-vc-class)#?
cbr Configure the Constant Bit Rate (CBR) service class
default Set a command to its default(s)
do Run an exec mode command (alias command run)
encapsulation Configure the ATM encapsulation
exit Exit from the current command mode
help Describe the interactive help system
inarp Configure the Inverse Address Resolution Protocol (InARP)
protocol
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
Chapter 2: Command-Line Interface
83