Ethernet Interface Configuration Commands; General Ethernet Interface Configuration Commands; Combo Enable - HP 830 Command Reference Manual

Ethernet interface configuration commands

General Ethernet interface configuration
commands

combo enable

Use combo enable to activate the copper or fiber combo port of a combo interface.
Syntax
combo enable { copper | fiber }
Default
The copper combo port of a combo interface is activated.
Views
Ethernet interface view (combo interface)
Default command level
2: System level
Parameters
copper: Activates the copper combo port. In this case, use twisted pairs to connect the port.
fiber: Activates the fiber combo port. In this case, use optical fibers to connect the port.
Usage guidelines
A combo interface is a logical interface that physically comprises one fiber combo port and one copper
combo port on the device panel. The two ports share one forwarding interface. As a result, they cannot
work simultaneously. When you activate either port, the other port is automatically disabled. You can
select to activate the copper combo port or fiber combo port.
Support for this command depends on the device model. For more information, see About the Command
References for HP Unified Wired-WLAN Products.
Examples
# Activate the copper combo port of combo interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] combo enable copper
# Activate the fiber combo port of combo interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] combo enable fiber
1