Ethernet Oam Configuration Task List; Configuring Basic Ethernet Oam Functions; Configuring The Ethernet Oam Connection Detection Timers - HP 5130 EI Series Configuration Manual

Ethernet OAM configuration task list

Tasks at a glance
(Required.)
(Optional.)
(Optional.)
•
Configuring errored symbol event detection
•
Configuring errored frame event detection
•
Configuring errored frame period event detection
•
Configuring errored frame seconds event detection
(Optional.)
(Optional.)
•
Enabling Ethernet OAM remote loopback on a specific port
•
Enabling Ethernet OAM remote loopback on the port
•
Rejecting the Ethernet OAM remote loopback request from a remote port

Configuring basic Ethernet OAM functions

To set up an Ethernet OAM connection between two Ethernet OAM entities, you must set at least one
entity to operate in active mode. An Ethernet OAM entity can initiate OAM connection only in active
mode.
To change the Ethernet OAM mode on an Ethernet OAM-enabled port, first disable Ethernet OAM on the
port.
To configure basic Ethernet OAM functions:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet port
view.
3. Set the Ethernet OAM mode.
4. Enable Ethernet OAM.
Configuring the Ethernet OAM connection
detection timers
After an Ethernet OAM connection is established, the Ethernet OAM entities exchange Information
OAMPDUs at the handshake packet transmission interval to detect the availability of the Ethernet OAM
Configuring basic Ethernet OAM functions

Configuring the Ethernet OAM connection detection timers

Configuring link monitoring
Configuring the action a port takes after it receives an Ethernet OAM event from the remote end
Configuring Ethernet OAM remote loopback
Command
System-view
interface interface-type
interface-number
oam mode { active | passive }
oam enable
4
Remarks
N/A
N/A
The default is active Ethernet OAM
mode.
Ethernet OAM is disabled by
default.