Dldp Reset; Dldp Unidirectional-Shutdown - HP 6125G Command Reference Manual

Use undo dldp interval to restore the default.
By default, the interval for sending Advertisement packets is five seconds.
This command applies to all DLDP-enabled ports.
Examples
# Set the interval for sending Advertisement packets to 20 seconds.
<Sysname> system-view
[Sysname] dldp interval 20

dldp reset

Syntax
dldp reset
View
System view, Layer 2 Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use dldp reset to reset the DLDP state for ports, enabling DLDP down ports to perform unidirectional link
detection.
When executed in system view, this command applies to all ports of the device. When executed in Layer
2 Ethernet interface view, this command applies to the current port.
Related commands: dldp enable and dldp unidirectional-shutdown.
Examples
# Reset DLDP state for all ports.
<Sysname> system-view
[Sysname] dldp reset
# Reset DLDP state for port GigabitEthernet 1/1/3.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/1/3
[Sysname-GigabitEthernet1/1/3] dldp reset

dldp unidirectional-shutdown

Syntax
dldp unidirectional-shutdown { auto | manual }
undo dldp unidirectional-shutdown
View
System view
55