Table of Contents
Advertisement
5.2.2
Clearing Sleep Mode
Sleep mode is cleared by any interrupt (timer A, timer C, timer F, timer G, asynchronous counter,
IRQ
to IRQ
, WKP
4
0
7
pin.
• Clearing by interrupt
When an interrupt is requested, sleep mode is cleared and interrupt exception handling starts.
A transition is made from sleep (high-speed) mode to active (high-speed) mode, or from sleep
(medium-speed) mode to active (medium-speed) mode. Sleep mode is not cleared if the I bit of
the condition code register (CCR) is set to 1 or the particular interrupt is disabled in the
interrupt enable register.
To synchronize the interrupt request signal with the system clock, up to 2/φ (s) delay may
occur after the interrupt request signal occurrence, before the interrupt exception handling
start.
• Clearing by RES input
When the RES pin goes low, the CPU goes into the reset state and sleep mode is cleared.
5.2.3
Clock Frequency in Sleep (Medium-Speed) Mode
Operation in sleep (medium-speed) mode is clocked at the frequency designated by the MA1 and
MA0 bits in SYSCR1.
, SCI1, SCI3-1, SCI3-2, or A/D converter), or by input at the RES
to WKP
0
Section 5 Power-Down Modes
Rev. 6.00 Aug 04, 2006 page 139 of 680
REJ09B0145-0600
Advertisement
Table of Contents
