Renesas H8/3847R Series Hardware Manual page 373

Bits 7 and 6: Operating mode select 1 and 0 (SNC1, SNC0)
Bits 7 and 6 select the operating mode.
Bit 7 Bit 6
SNC1 SNC0
0 0
0 1
1 0
1 1
Notes: 1. Use pins SI
2. Do not set bits SNC1 and SNC0 to 11.
Bit 5: TAIL MARK control (MRKON)
Bit 5 controls tail mark output after transfer of 8-bit or 16-bit data.
Bit 5
MRKON Description
0 TAIL MARK is not output (synchronous mode)
1 TAIL MARK is output (SSB mode)
Bit 4: LATCH TAIL select (LTCH)
Bit 4 selects whether LATCH TAIL or HOLD TAIL is output as the tail mark when MRKON = 1
(i.e. in SSB mode).
Bit 4
LTCH Description
0 HOLD TAIL is output
1 LATCH TAIL is output
Description
8-bit synchronous mode
16-bit synchronous mode
Continuous clock output mode *
Reserved *
2
and SO as ports.
1 1
Section 10 Serial Communication Interface
1
Rev. 6.00 Aug 04, 2006 page 335 of 680
(initial value)
(initial value)
(initial value)
REJ09B0145-0600