Table of Contents
Advertisement
6.2
PROM Mode (H8/3847R)
6.2.1
Setting to PROM Mode
If the on-chip ROM is PROM, setting the chip to PROM mode stops operation as a
microcontroller and allows the PROM to be programmed in the same way as the standard
HN27C101 EPROM. However, page programming is not supported. Table 6.1 shows how to set
the chip to PROM mode.
Table 6.1
Setting to PROM Mode
Pin Name
TEST
PB
/AN
4
4
PB
/AN
5
5
PB
/AN
6
6
6.2.2
Socket Adapter Pin Arrangement and Memory Map
A standard PROM programmer can be used to program the PROM. A socket adapter is required
for conversion to 32 pins, as listed in table 6.2.
Figure 6.2 shows the pin-to-pin wiring of the socket adapter. Figure 6.3 shows a memory map.
Table 6.2
Socket Adapter
Package
100-pin (FP-100B)
100-pin (FP-100A)
100-pin (TFP-100B)
100-pin (TFP-100G)
Setting
High level
Low level
High level
Socket Adapter Model (Manufacturer)
ME3887ESHS1H (MINATO)
H7388BQ100D3201 (DATA-I/O)
ME3887ESFS1H (MINATO)
H7388AQ100D3201 (DATA-I/O)
ME3887ESNS1H (MINATO)
H7388BT100D3201 (DATA-I/O)
ME3887ESMS1H (MINATO)
H7388GT100D3201 (DATA-I/O)
Rev. 6.00 Aug 04, 2006 page 157 of 680
Section 6 ROM
REJ09B0145-0600
Advertisement
Table of Contents
