Renesas H8/3847R Series Hardware Manual page 397

Bit 3: Multiprocessor interrupt enable (MPIE)
Bit 3 selects enabling or disabling of the multiprocessor interrupt request. The MPIE bit setting is
only valid when asynchronous mode is selected and reception is carried out with bit MP in SMR
set to 1. The MPIE bit setting is invalid when bit COM is set to 1 or bit MP is cleared to 0.
Bit 3
MPIE Description
0 Multiprocessor interrupt request disabled (normal receive operation)
Clearing condition:
When data is received in which the multiprocessor bit is set to 1
1 Multiprocessor interrupt request enabled*
Note: * Receive data transfer from RSR to RDR, receive error detection, and setting of the
RDRF, FER, and OER status flags in SSR is not performed. RXI, ERI, and setting of
the RDRF, FER, and OER flags in SSR, are disabled until data with the multiprocessor
bit set to 1 is received. When a receive character with the multiprocessor bit set to 1 is
received, bit MPBR in SSR is set to 1, bit MPIE is automatically cleared to 0, and RXI
and ERI requests (when bits TIE and RIE in serial control register 3 (SCR3) are set to
1) and setting of the RDRF, FER, and OER flags are enabled.
Bit 2: Transmit end interrupt enable (TEIE)
Bit 2 selects enabling or disabling of the transmit end interrupt request (TEI) if there is no valid
transmit data in TDR when MSB data is to be sent.
Bit 2
TEIE Description
0 Transmit end interrupt request (TEI) disabled
1 Transmit end interrupt request (TEI) enabled*
Note: * TEI can be released by clearing bit TDRE to 0 and clearing bit TEND to 0 in SSR, or by
clearing bit TEIE to 0.
Bits 1 and 0: Clock enable 1 and 0 (CKE1, CKE0)
Bits 1 and 0 select the clock source and enabling or disabling of clock output from the SCK
The combination of CKE1 and CKE0 determines whether the SCK
a clock output pin, or a clock input pin.
The CKE0 bit setting is only valid in case of internal clock operation (CKE1 = 0) in asynchronous
mode. In synchronous mode, or when external clock operation is used (CKE1 = 1), bit CKE0
should be cleared to 0.
Section 10 Serial Communication Interface
pin functions as an I/O port,
3X
Rev. 6.00 Aug 04, 2006 page 359 of 680
(initial value)
(initial value)
pin.
3X
REJ09B0145-0600