Communication Board Ethernet Cbe20 (Option G33) - Siemens SINAMICS S150 Operating Instructions Manual
Converter cabinet units 75 kw to 1200 kw
Hide thumbs
Also See for SINAMICS S150:
- Engineering manual (530 pages) ,
- Manual (312 pages) ,
- Function manual (108 pages)
Table of Contents
Advertisement
Electrical installation
4.9 Other connections
Diagnosis
Messages output during operation and in the event of faults (meaning of LEDs on –A101)
are described in "Additional Operating Instructions" in the operating manual.
4.9.15
Communication Board Ethernet CBE20 (option G33)
Description
Interface module CBE20 is used for communication via PROFINET.
The module is delivered mounted in a supplementary pack on the CU320 Control Unit and
must be installed line-side in the option slot of the CU320 Control Unit.
4 Ethernet interfaces are available on the module. Diagnosis of the function mode and
communication are possible via LEDs.
Interface overview
Figure 4-13
MAC address
The MAC address of the Ethernet interfaces is indicated on the upper side of the CBE20.
The label is only visible when the module has not yet been installed.
Note
Please note the MAC address prior to installing the module so that it is available to you for
the subsequent commissioning.
90
Communication Board Ethernet CBE20
Drive converter cabinet units
Operating Instructions, 07/07, A5E00288214A
Advertisement
Table of Contents
