Connecting Cable Shields (Fsd; Fieldbus Interfaces; Connecting The Inverter To Profinet; Communication Via Profinet Io And Ethernet - Siemens SINAMICS G120C USS/MB Operating Instructions Manual

Installing
4.9 Connecting the interfaces for the inverter control
4.9.7.2 Connecting cable shields (FSD ... FSF)
Connect cables at the inverter so that they are EMC compliant
Attach the cable tie holders to the Power Mod‐
ule as shown to the left in the diagram before
you establish the connections.
Fix the line connecting cable using a cable tie
as shown in
Fix the shield of the motor connecting cable
using a hose clamp (
Connect the shield of the control cable with the
shield plate of the Control Unit (
steel band. Also attach the control cable to the
Power Module using a cable tie (
4.9.8

Fieldbus interfaces

Fieldbus interfaces of the Control Units
The Control Units are available in different versions for communication with higher-level
controls with the subsequently listed fieldbus interfaces:
Fieldbus
PROFINET
EtherNet/IP
PROFIBUS
USS
Modbus RTU
Information on PROFIsafe can be found in the "Safety Integrated" function manual.
1)
Information about these fieldbuses, profiles and communication types can be found in the
2)
"Fieldbus" function manual.
4.9.9

Connecting the inverter to PROFINET

4.9.9.1

Communication via PROFINET IO and Ethernet

You can either integrate the inverter in a PROFINET network or communicate with the inverter
via Ethernet.
104
①
.
②
).
PROFIdrive
✓
2)
✓
2)
2)
Overview of the manuals (Page 459)
③
) using a
④
).
Profiles
PROFIsafe PROFIenergy
1)
✓ ✓
---
✓ ---
---
---
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34263257B AF
S7 commu‐ Control Unit
nication
2)
2)
✓ G120C PN
---
✓ G120C DP
--- G120C USS/MB
---
SINAMICS G120C converter