R&S ESR Series User Manual page 528

®
R&S ESR
If the number of error messages exceeds the capacity of the error buffer, "Message
buffer overflow" is displayed. To delete messages, see
on page 525 softkey.
Remote command:
SYSTem:ERRor:LIST?
Clear All Messages ← System Info
Deletes all system messages. The softkey is only available if the "System Messages"
dialog box is displayed.
Remote command:
SYSTem:ERRor:CLEar:ALL
Parameter Coupling
Opens a dialog box to couple or decouple various parameters.
If the coupling of a parameter is on, its value is transferred when you switch from
receiver into another operating mode and vice versa. Coupling of the following parame-
ters is supported.
●
Frequency
●
Span (start and stop frequencies)
●
Marker frequency
●
RF attenuation and unit
●
10 dB Minimum Attenuation
●
Preamplifier state
●
Preselector state
Note that the preselector is always on in receiver mode.
●
Audio demodulation settings
●
Bandwidth settings (including filter type)
●
Limit lines
Limit lines are only transferred if they are compatible to the current diagram config-
uration.
Remote command:
See
Firmware Update
Opens the "Firmware Update" dialog box.
Enter the name of or browse for the firmware installation file and press the "Execute"
button. For details on installation, refer to
tion of Firmware
Only user accounts with administrator rights can perform a firmware update.
Remote command:
SYSTem:FIRMware:UPDate
Option Licenses
Opens a submenu to install options. For details on options, refer to
ware Update and Installation of Firmware
The submenu contains the following commands:
●
"Install Option"
User Manual 1175.7068.02 ─ 12
Instrument Setup and Interface Configuration – SETUP Key
on page 927
Chapter 11.9.3, "Coupling
Options", on page 60.
on page 526
on page 926
Parameters", on page 927
Chapter 3.3, "Firmware Update and Installa-
on page 921
Options", on page 60.
System Configuration
"Clear All Messages"
Chapter 3.3, "Firm-
525